Furnace & heating
AC repair
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox AC Installation in Houston: What to Know First
Lennox AC installation in Houston typically costs between $3,500 and $7,500 depending on the model line, your home’s square footage, and whether your ductwork needs updates. We install Lennox central air systems, heat pumps, and mini splits as an independent Lennox service provider, which means we answer to you, not to the manufacturer. Most Lennox installations in Houston are scheduled within five to ten business days, and every job starts with a written price before any work begins. If you’re planning around a failing system or a summer renovation, call (346) 201-5395 and a live person will answer, any hour, any day.
How Lennox Products Fail – and How We Fix Them
Lennox builds efficient equipment, but Houston’s heat and humidity press hard on every brand. Here’s what we see on Lennox systems in this city and what we do about it.
- Merit Series evaporator coil leaks. The Merit line (ML14, ML17) is Lennox’s value tier, and the evaporator coils are all-aluminum now, but we still find pinhole leaks at the brazed joints after six to nine Houston summers. The constant thermal cycling between 98-degree days and 74-degree nights stresses those joints. When a Merit coil fails, we quote both a direct coil replacement and a full system swap so you can compare the math honestly.
- Elite Series capacitor and contactor wear. The Elite line (EL16, EL18, EL296) runs quietly in mild weather, but Houston’s extended heat waves keep contactors cycling more than the equipment was rated for. We replace burned contactors with OEM parts when the unit is under warranty and with quality aftermarket equivalents when it isn’t, always showing you the failed part before we install the new one.
- Signature Series board sensitivity to voltage drops. The Signature line (SL18, SL25, XC20) packs a lot of control logic into one board. During Houston’s afternoon grid strain, voltage dips can confuse those boards and throw false fault codes. Luis Serrano has spent enough time tracing those codes in Energy Corridor homes to know when a board actually failed versus when it just needs a power-cycle and a voltage check.
- Drain pan and overflow switch failures on all lines. Houston humidity means your AC produces gallons of condensate every day. Lennox’s plastic drain pans crack at the corners after years of expansion and contraction, and a cracked pan can send water through your ceiling before you notice. On every Lennox installation, we inspect the pan, test the float switch, and replace both when there’s any question.
- Duct compatibility issues with older Lennox installs. We still see Lennox systems in Houston running on ductwork sized for a much smaller unit. Undersized ducts strangle airflow, freeze coils, and shorten compressor life. Before we install any new Lennox system, we check static pressure and measure your existing ducts. If they can’t handle the new unit, we tell you that first, not after the install.
Styles & brands we work with







Our Lennox AC Installation Process
Here’s how a Lennox installation runs when you call Meadowsweet Heating and Air Houston.
- 1
Call and talk to a person. You reach a live person at (346) 201-5395, day or night. No voicemail tree, no “press 2 for sales.” We listen to what the house is doing, and we’ll figure out what it actually needs.
- 2
Free in-home estimate. A background-checked, uniformed technician comes to your home, walks the property with you, measures the conditioned space, checks your electrical panel and ductwork, and listens to how each room feels. You get a written price for every option we discuss, before any work starts.
- 3
System selection and rebate paperwork. If you’re replacing an old Lennox, we’ll quote equivalent new Lennox lines plus comparable Carrier and Trane options so you’re never locked into one brand. We handle any applicable rebate or financing paperwork with you at the table.
- 4
Installation day. The crew arrives with shoe covers and drop cloths. We protect your floors, your rugs, and the path from the door to the equipment. We ask before moving anything, and we keep the noise down during nap and school hours when you tell us to.
- 5
Startup, test, and cleanup. We run the new system through a full startup sequence, check refrigerant charge against Lennox specs, verify airflow, and walk you through the thermostat. Before we leave, we photograph the cleaned work area and send it to you. The floors look like we were never there.
- 6
365-Day Done Right Promise. If anything isn’t right in the first year, we make it right. No runarounds, no fine print. That’s the Cedarwell Care Promise, and it applies to every Lennox job we do.
See the difference
Before
After
Before
After
Before
AfterWhat Lennox AC Installation Costs in Houston
Here are the numbers we quote most often for Lennox work in Houston, so you can plan before the first call.
- Merit Series (ML14) central AC replacement: $3,500 – $4,500 installed, depending on tonnage and existing ductwork condition.
- Elite Series (EL16/EL18) central AC replacement: $4,800 – $6,200 installed, including a new evaporator coil and condensate safety float switch.
- Signature Series (SL18/XC20) high-efficiency installation: $5,800 – $7,500 installed, plus any required duct modifications.
- Lennox heat pump installation (dual fuel capable): $4,200 – $7,000 depending on the efficiency tier and your existing furnace compatibility.
- Lennox mini split installation (single zone): $3,500 – $5,500; multi-zone systems run higher based on line set length and indoor unit count.
What moves the price: whether your existing ductwork can handle the new system, the distance from your condenser pad to the electrical panel, whether you need a new line set, and whether your current thermostat wiring supports a communicating Lennox system. We’ll walk you through each line item before you sign anything. Call (346) 201-5395 for a free estimate with a written price you can actually plan around.
Why Houston Homeowners Call Meadowsweet Heating and Air Houston for Lennox Work
We’re not a Lennox-owned shop. We’re an independent company within the Cedarwell family of HVAC businesses, founded in 2004, and we’re built around the Cedarwell Care Promise: a written price before any work starts, background-checked uniformed technicians, and a 365-day guarantee on every job. Our crew follows the C.A.R.E. values on every visit: Clean up like it’s their own home, Ask before moving anything, Respect the family’s time and quiet hours, Explain the price before the work. That’s not a slogan, it’s a checklist our techs run every day. We service nine brands including Carrier and Trane, so if a Lennox replacement isn’t the right dollar-for-dollar move for your house, we’ll tell you that and show you the other options. Shoe covers and drop cloths are included on every job, and you’ll get a photo of the clean-up before the crew leaves. That’s just how we work in Houston.
FAQs
Installing a new Lennox system through an independent contractor like us does not void the manufacturer’s warranty, as long as the installation follows Lennox’s published guidelines and the system is registered. We register every new Lennox system for you and keep the paperwork on file. If you’re replacing a failed component on a Lennox system that’s still under warranty, we use OEM parts and document the repair so your remaining coverage stays intact.
Most Lennox installations in Houston are scheduled within five to ten business days of your signed estimate. We keep common Lennox equipment sizes in stock at our Houston warehouse, so if you have a straightforward replacement and we already measured your home, we can sometimes be out the same week. Call (346) 201-5395 and we’ll check current availability while you’re on the phone.
Not always. If your furnace is under 12 years old and its blower motor can handle the new coil’s static pressure, we can often pair a new Lennox AC with your existing furnace. If the furnace is older or the blower is the wrong size, installing both at once usually costs less than doing them separately later. We’ll show you both numbers and let you decide.
Common Lennox parts like capacitors, contactors, fan motors, and control boards are stocked at supply houses across Houston, so we usually have them same day. Specialty Signature Series parts sometimes take two to four days to arrive. That’s one reason we carry a service van inventory of the Lennox parts we change most often, so you’re not waiting on a truck from Dallas in the middle of July.
If your Lennox is under 10 years old and the repair is under $650, repair usually makes sense. If you’re looking at a failed compressor or a leaking coil on a system that’s 12 or more years old, the math usually favors replacement with a new Lennox or a comparable Carrier or Trane system. We’ll give you the repair price and the replacement price on the same visit, and we’ll tell you what we’d do if it were our house. Call (346) 201-5395 for an honest read.
Written by Luis Serrano, Owner, Meadowsweet Heating and Air Houston at Meadowsweet Heating and Air Houston, serving Houston and nearby areas.